Simplify Your Oversize/Overweight Loads

  • Instantly Determine Permit & Escort Costs
  • Optimize Your Quote, Permit Processes
  • Understand Equipment Limits

Carriers
Brokers / 3PLs
Owner Ops
Shippers

New York City Oversize/Overweight Permit And Regulations

Note: For state regulations, see OD Regulations By State


Size and Weight Restrictions

Commercial vehicles may not travel on parkways. All commercial drivers must use Local and Through truck routes to the intersection nearest their destination. All posted restrictions must be obeyed. Vehicles exceeding any of these dimensions must obtain a daily over-dimensional vehicles permit for each trip (going and coming back).

Tractor-trailer vehicle combinations not exceeding 13'6" in height, 8' in width, and 55' in length can travel on interstates and truck routes. The maximum allowed length of single unit vehicles, such as boxtrucks, is 35'.

Federal STAA vehicles not exceeding 13'6" in height, 8'6" in width, and 48' trailer length, and lower of the bridge formula weight or 80,000 pounds, moving household goods can travel on interstates and truck routes. STAA vehicles not moving household goods are limited to one-mile access to and from the exit.

Trucks with 53-foot trailers may only travel on the portions of I-95, I-695, I-295, and I-495 that cross the city between the Bronx-Westchester County line and Queens-Nassau County line. 53-foot trailers carrying non-divisible loads must apply for a New York City Permit. 

Maximum weight limit for vehicles is 80,000 pounds or less, depending upon axle spacing. Bridges or viaducts may have lower weight limits posted. The legal weights are outlined below. All vehicles must obey posted capacity or height clearance of all structures.

Legal Weights for Trucks with Pneumatic Tires

Per Inch of Tire Width - 800 lbs.
Any One Wheel - 11,200 lbs.
Any One Axle - 22,400 lbs.
Any Two Axles (1) - 36,000 lbs.
3 or More Axle - 80,000 lbs.(2)

Vehicle equipped with solid rubber tires is permitted up to 80% of legal load for pneumatic tires.

(1) When such axles are spaced less than 10 feet, but not less than 46.
(2) Maximum weight limit is computed as 34,000 lbs., plus 1,000 lbs. per foot of distance between the first and last axles. 80,000 lbs. is the outer limit for all cases.


For New York City Highway and Traffic Rules see http://www.nyc.gov/html/dot/html/motorist/traffic_rules.shtml

For New York City Permit information see http://www.nyc.gov/html/dot/html/motorist/oversize.shtml

For STAA vehicles dimension and access information sheet see http://www.nyc.gov/html/dot/downloads/pdf/vehdimen.pdf

For Local and Through Truck routes see http://www.nyc.gov/html/dot/html/motorist/truckrouting.shtml

For Truck Access and Vehicle Dimension Guidelines for New York see http://www.nyc.gov/html/dot/downloads/pdf/truckaccess.pdf


Simplify Your Oversize/Overweight Loads

  • Instantly Determine Permit & Escort Costs
  • Optimize Your Quote, Permit Processes
  • Understand Equipment Limits

Carriers
Brokers / 3PLs
Owner Ops
Shippers