The power of the permit agency in the palm of your hand

Automate your oversize/overweight quotes, axle compliance and permits with oversize.io

See how it works

Washington Tire Regulations

Chain requirement for commercial vehicles

All vehicles over 10,000 pounds gross vehicle weight (GVW) shall carry a minimum of two (2) extra chains for use in the event that road conditions require the use of more chains or in the event that chains in use are broken or otherwise made useless,
WAC 204-24-050 (2) (f).

Approved chains for vehicles over 10,000 pounds gross vehicle weight shall have at least two side chains to which are attached sufficient cross chains of hardened metal so that at least one cross chain is in contact with the road surface at all times. Plastic chains shall not be allowed. The Washington State Patrol may approve other devices as chains if the devices are equivalent to regular chains in performance (cable chains allowable).

Diagram of proper chain placement (pdf 20kb) for different axle configurations

On the following routes all vehicles and combinations of vehicles over 10,000 pounds shall carry sufficient tire chains to meet the requirements from November 1 to April 1 of each year or at other times when chains are required for such vehicles:

I-90 between North Bend (MP 32) and Ellensburg (MP 101)

I-82 between Ellensburg Exit 3 (MP 3.00) and Selah Exit 26 (MP 26.00)

SR-97 between (MP 145) and Junction

SR-2 between Dryden (MP 108) and Index (MP 36)

SR-12 between Packwood (MP 135) and Naches (MP 187)

SR-97 between junction SR-14 (MP 4) Columbia River and Toppenish (MP 59)

SR-410 from Enumclaw to Naches

SR-20 between Tonasket (MP 262) and Kettle Falls (MP 342)

SR-155 between Omak (MP 79) and Nespelem (MP 45)

SR-970 between (MP 0) and (MP 10)

SR-14 (MP 18) to Junction 97 (MP 102)

SR-542 Mt Baker Highway between (MP 22.91) and (MP 57.26)

Vehicles making local deliveries as indicated on bills of lading and not crossing the mountain pass are exempt from this requirement if operating outside of chain required area.

The Washington State Department of Transportation or Washington State Patrol may prohibit any vehicle from entering a chain/approved traction tire control area when it is determined that the vehicle will experience difficulty in safely traveling the area.

Oversize Load Movements

Movement by permit on mountain passes is prohibited where any of the following signs are displayed:

Traction Advisory/Oversized Vehicles Prohibited.

Vehicles over 10,000 GVWR, Chains Required.

Chains required on all vehicles except all-wheel drive.

http://www.wsdot.wa.gov/commercialvehicle/chain_req.htm

Calculate Oversize/Overweight Load Regulations and Prices Instantly with Oversize.io